Home › Forums › Design and Building › Effects Design and Construction › Following 2 Power Tube Amp Design › Re: Re: Following 2 Power Tube Amp Design
Wait a minute. Do you mean to say that only the shielding is soldered to the 68K resistor from the tip of the input jack? So i use the outer copper braid to run from 68K directly to the #2 pin on V1? I am sure that is my problem if this is so, as of now, I have the 68K wired to the inner conductor and to pin #2 and the outer shield just grounded on the mounting bolt via a grounding star. Wow how did I miss that if I am reading you correctly.
As for continuity if it even matters after my above statement…It was fine up until the V1 side of the 68K resistor, which might now make much more sense!
Again I love this site!